Presenting the Mission Engineering SP-HR "Aero" Expression Pedal designed for use with the HeadRush Pedalboards. Connect to the EXPR2 port on the Headrush with a single TRS cable. The pedal works along side the on board pedal in both Classic and Advanced mode. Use the integrated toe switch to turn...

Dual footswitch for HX Stomp! It is switchable between RS mode and TS mode, and in TS mode it uses two standard TS cables, perfect for adding footswitches to two separate devices. This is a beautiful item with little use. Age: 2020s. Accessories: box In charge of : Sano (Sano) ※Warranty period is...

Tested in great working condition. Bottom plate is slightly dented from use, fully functional otherwise.

The Mission Engineering VM-1 Volume Pedal takes a pedalboard staple and infuses it with high-end boutique construction and features like hand-wired input and outputs connected through the potentiometer, an isolated tuner out employing a mute switch, and hard-as-nails cold-rolled steel chassis....

Velocity is a dual gain level overdrive and distortion pedal for guitar.The LO gain setting is perfect for subtle overdrive and pushing the front end of an amp slightly harder. It works well as a boost for low output single coil pickups to get the amp and speaker into breakup. Higher drive levels...

The Mission VM-PRO is the most sophisticated volume pedal ever made. Using quality components and designed to exacting specifications, the VM-PRO introduces several innovative features never seen before in a volume pedal.The VM-PRO resolves many of the common issues with volume pedals that cause...

The Expressionator multi-expression controller allows musicians to connect one expression pedal with up to three expression enabled effects and control them individually or simultaneously.Expressionator provides a powerful set of features for expression control.1. Three stomp switch selectable...

From Mission Engineering:The 529i features 2 x 500mA and 6 x 300mA 9V fully isolated outputs. With a 1A load, the 529i will power your pedalboard for 2 hours on a single charge. Recharge using the included 12V power supply, or from any USB charger.The isolated 5V USB output can be used to charge...

The iSeries 3i-2015-7TMP features a custom, high-quality foam interior that’s been form-cut to accommodate the Fender Tone Master Pro Guitar Workstation. There are accessory compartments below the workstation and behind it providing space for all the gig necessities. The accessory pocket behind the...